The DCM-PRO mat must be installed onto a freshly cleaned, smooth flat surface, free of dust. ah4> A SBR primer must be used if installing directly onto a concrete or timber subfloor. Make sure that you press the mat firmly in place to ensure the pressure sensitive adhesive makes full contact and securely binds the […]
Why is the DCM-PRO mat not sticking to the subfloor? Read More »
An SBR based primer should be used when installing the DCM-PRO mat directly onto a timber or concrete base. It is not necessary to us the SBR primer when installing onto a the Warmup insulation boards. Please refer to the installation manual for further information.
When should you use an SBR based primer with DCM-PRO? Read More »
The Dual Overlay is an MDF board with an interactive adhesive that fixes the top board to the base board. See the full technical specification of the dual overlay boards.
What are the Dual Overlay board made from? Read More »
The boards can easily be cut using a utility knife.
How do I cut the Dual Overlay boards? Read More »
The dual overlay system is not suitable for use in wet areas due to the composition of the boards. If installing vinyl into a wet area an alternative underfloor heating system will need to be installed. The Loose Wire or StickyMat system can be used in this situation but must be covered by a 10mm self-levelling
Can the Dual Overlay be used in wet areas? Read More »
The dual overlay system is designed for use with Carpet and Vinyl flooring. The overlay boards must not be used with tiles or wood flooring, please see the technical specification sheet for more information.
What flooring can the Dual Overlay system be used under? Read More »
If the foil heater is damaged during installation there are number of options available: 1) Safety Net Warranty If the heater is damaged during installation you can return the heater to Warmup and we will replace the heater free of charge for the same size model. (The warranty covers one heater per household/installer, please see
What if I damage the Foil Heater during / after installation? Read More »
No – the Foil Heaters are completely earthed, and can be installed without any additional grounding nets. The foil layer acts as a continuous earth and it is important that it is kept intact. See the foil installation manual for further information. Also check out the video on installing the Foil Heater below:
Do you need to use grounding nets with the Foil Heater? Read More »
Yes, the Foil Heater has an Ip rating of X7, making the system suitable for use in wet areas when used with wood flooring. As with all underfloor heating installations the Foil heater must be protected by a 30mA RCD at all times. Please note: This does not apply if using the foil heaters in
Can the Foil Heater be used in wet areas? Read More »
We’re happy to answer all your questions about Warmup’s wide range of underfloor heating systems and thermostats.
Warmup offers an extensive range of electric and water floor systems compatible with all floor types, rooms and projects.
![Thumbnail [200x250]](/wp-content/uploads/Electric-Category-Page-Image.jpg)
![Thumbnail [200x250]](/wp-content/uploads/Hydronic-Category-Page-Image-1.jpg)
![Thumbnail [200x250]](/wp-content/uploads/6iE-Projects.jpg)
